Presented in Partnership with:
 
 

Ask the Expert Question-and-Answer Archive
(Hard Chrome Plating)

by Randy Taylor, Advanced Tooling Corporation.
August, 2008

Cadmium Vs. Zinc Plating

Q. We have a recent government contract which call out a series of mil-spec fasteners, but with zinc plating. These fasteners are readily available in the usual mil-spec cadmium plate. They are to be used in an aluminum assembly. Would I be reasonable in asking the program manager to allow the cadmium fasteners in lieu of zinc plating?

A. Richard, Cadmium and zinc are both in a class known as "sacrificial coatings", which are primarily used to protect steel (ferrous) base metals. Cadmium is superior to zinc but due to its toxicity has limited use. If zinc is being called out in the aluminum assembly, cadmium would behave the same or better in that environment.

Best of luck.

Randy Taylor

 

 

 

 


The information contained in this site is provided for your review and convenience. It is not intended to provide legal advice with respect to any federal, state, or local regulation.
You should consult with legal counsel and appropriate authorities before interpreting any regulations or undertaking any specific course of action.

Please note that many of the regulatory discussions on STERC refer to federal regulations. In many cases, states or local governments have promulgated relevant rules and standards
that are different and/or more stringent than the federal regulations. Therefore, to assure full compliance, you should investigate and comply with all applicable federal, state and local regulations.