Ask the Expert Question-and-Answer Archive (Wastewater Treatment)

by Mike McGinness, EcoShield Environmental Systems, Inc.
January, 2003

Will MP&M effect me?

Q. We are a "existing point source" job shop, for "zinc only on low carbon steel". We discharge over >10,000 gpd of electroplating effluent [average analytical results for three day comp. ph=9.33,(cd)=.019,chromium(T)=1.00, nickel=.078,(zc)=2.00 to the treatment plant here in Nashville, Tn. every 24 hours. How will the EPAs "new" effluent limitations guidelines effect this operation after Febuary,14 2003.If the EPA follows the D.C. courts instructions, layed out Nov.11, 2002?

A. From what I have read recently (and as I recall) if you are already regulated as a metal finisher the EPAs currently, and most recently stated opinion was that the final rule would leave your situation unchanged. Obviously this is only conjecture on their part part until the final rule is in print as the final rule.

 

 


The information contained in this site is provided for your review and convenience. It is not intended to provide legal advice with respect to any federal, state, or local regulation.
You should consult with legal counsel and appropriate authorities before interpreting any regulations or undertaking any specific course of action.

Please note that many of the regulatory discussions on STERC refer to federal regulations. In many cases, states or local governments have promulgated relevant rules and standards
that are different and/or more stringent than the federal regulations. Therefore, to assure full compliance, you should investigate and comply with all applicable federal, state and local regulations.