NMFRC
 

NCMSCompliance Assistance Centers

Funded by EPA
through a Cooperative Agreement

EPA

Disclaimer
The information contained in this site is provided for your review and convenience. It is not intended to provide legal advice with respect to any federal, state, or local regulation. You should consult with legal counsel and appropriate authorities before interpreting any regulations or undertaking any specific course of action.

Ask the Expert Question-and-Answer Archive (Wastewater Treatment)

by Mike McGinness, EcoShield Environmental Systems, Inc.
November, 2006

Clarifiers

Q. I run an oxidation ditch with extended aeration with 4 secondary clarifiers. I am having problems with solids carryover to the wiers, Our daily flows are minimal about 1500m3/day, split between 2 clarifiers in operation. The volume of these are 620m3 each standard rectangular design. Hydraulic flows are so low could this cause the problem? Solids in each clarifier is low about 200kg of mass per. Is there anything you can recommend to stop the carry over?

A. I would need to know more specifics about your operation. What kind of waste water are you treating, or in other words, what is in it? What is inlet BOD, COD, O&G, and are there any heavy metals? Is it metal finishing waste water, food industry, or sanitary waste water....or a mix, or something else? What chemicals and concentrations are in the waste water, like high sugar, grease, nitrogen?

What is your MLSS concentration in the oxidation ditch? Are you recycling solids from the clarifiers back to the oxidation ditch and if so what is the rate? Also what is your DO (disolved oxygen) concentration in the oxidation ditch? It needs to be controlled at about 2.0 mg/l of O2!

Sincerely,

Mike McGinness



| Compliance Assistance | Regulations | Directories | Resources | Hot Topics | News | Ask the Experts | Library | Online Training | About NMFRC | Search | Home |

NMFRC